<VV> Convertible Sun Visors

[Charles Lee]

Not sure about sun visors on early convertibles, but be careful tightening
the bracket on the outside ends of the big metal piece that locks the top
down to the windshield header, since the metal can break, requiring the
whole piece to be replaced (to be done correctly.)

The bracket will still hold the visor, but you will know you broke it every
time you look at it.

I learned this the hard way :<{

Charles Lee


-----Original Message-----
From: VirtualVairs [mailto:virtualvairs-bounces at corvair.org] On Behalf Of
James Weppelman via VirtualVairs
Sent: Wednesday, November 11, 2015 5:05 PM
To: virtualvairs at corvair.org
Subject: <VV> SUN VISOR

Yinz guys,
I've used a piece of sandpaper, say 150 wet/dry. Cut a small strip and fold
it back over itself. Put it on the male part of the sun visor, and tighten
as usual. Gives it enough friction to hold up, but not to much to pull down.
Jim Weppelman
Pittsburgh
61 Lakewood
63 spyder rag project
64 Monza cpe fac/ac 
 		 	   		  
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are
the property
of the writer, please attribute properly. For help,
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America,
http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
 _______________________________________________