<VV> Centering the Pressure Plate

Marc Sheridan sheridanma1966 at gmail.com
Mon Oct 12 14:11:48 EDT 2015


I think you mean the clutch disk. It is very simple, use the input shaft.
While you're at it, check the pilot bearing and the input shaft seal.

On Mon, Oct 12, 2015 at 12:53 PM, edward szuch via VirtualVairs <
virtualvairs at corvair.org> wrote:

> I'm putting a '66 140 4-speed back together and I'm wondering if there is a
> best way to center the pressure plate on the flywheel?  It's unbelievable
> there aren't any dowels between the two.
>
> Thank you!
>
> Gary Szuch
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are
> the property
> of the writer, please attribute properly. For help, mailto:
> vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options:
> http://www.vv.corvair.org/mailman/options/virtualvairs
> Archives: http://www.vv.corvair.org/archive.htm
>  _______________________________________________
>


More information about the VirtualVairs mailing list