<VV> 1964 Hood weatherstrip channel steel?

Larry Forman larry at forman.net
Sat May 7 02:36:33 EDT 2016


Use POR-15 and window fiberglass screening material to fill in any 
gaps.   See the POR15.com web site and call them if you need guidance.  
This approach is a LOT less expensive. Just follow their directions 100%.

Good luck,

Larry Forman

On 5/6/2016 11:16 PM, Ignacio Valdes via VirtualVairs wrote:
> Hi, My 1964 convertible hood weatherstrip channel needs steel. I could
> fabricate it but I don't think it would turn out that great.  Is there a
> common piece of steel that is close to the weatherstrip channel that I can
> weld on? In some places the channel is gone. Clark's doesn't seem to have
> this for hood. Does seem to have it for trunk.
>
> -- IV
>   _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
> Archives: http://www.vv.corvair.org/archive.htm
>   _______________________________________________



More information about the VirtualVairs mailing list