<VV> Tach Fix
frankcb at aol.com
frankcb at aol.com
Sun May 7 14:54:55 EDT 2017
Brian, if disconnecting the wire(s) at the back of the tach doesn't cause the tach needle to return to zero, then your problem is most likely an internal MECHANICAL one restricting movement of the tach needle.
Frank Burkhard
-----Original Message-----
From: Brian via VirtualVairs <virtualvairs at corvair.org>
To: VirtualVairs <VirtualVairs at corvair.org>
Sent: Sun, May 7, 2017 1:01 pm
Subject: <VV> Tach Fix
Any tricks to getting a tach to go to zero when the engine is shut of? It stops at 2,000 RPM.
____________________________________________________________
Avoid Botox: How To Remove Eye Bags & Wrinkles In 1 Minute
Fit Mom Daily
http://thirdpartyoffers.juno.com/TGL3131/590f52c9771f852c974e1st01vuc
_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
_______________________________________________
More information about the VirtualVairs
mailing list