<VV> Turn signal mechanism

[hugo at aruncoaches.co.uk]

I think I may have resolved this - there is a notch cut out of the 
housing for the cable, but my cable isn't actually sitting in the notch 
- it is hiding in a deeper groove in the mast itself.
I'll try re-routing it & see what happens. It's certainly a weird 
design - luckily I am familiar with it as my Impala has the same switch 
mechanism.


On 2017-10-25 07:56, Hugo Miller via VirtualVairs wrote:
> I have an issue with that little cable that goes from the mechanism
> in the steering wheel down the mast to the switch. Where the cable
> loops around that little bent piece of wire (the one that acts as a
> bell-crank & changes side-to-side motion to up & down motion), the
> loop at the end of the cable keeps popping off the end of the bell
> crank. Nothing I do makes it stay on there. I just had the steering
> wheel off to repaint it, but that's all. Did I disturb something
> further down perhaps?
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all
> copyrights are the property
> of the writer, please attribute properly. For help,
> mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America,
> http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: 
> http://www.vv.corvair.org/mailman/options/virtualvairs
> Archives: http://www.vv.corvair.org/archive.htm
> _______________________________________________