<VV> Depth of bellhousings

[Jim Becker]

What does matter is the total distance from the rear motor mount to the 
center line of the differential.  That needs to remain the same.  Any 
difference in the bell housing would have to be made up by the differential 
housing.

Jim Becker

-----Original Message----- 
From: Robert Marlow, Vairtec Corporation via VirtualVairs
Sent: Thursday, June 21, 2018 11:04 AM
To: virtualvairs at corvair.org
Subject: Re:  Depth of bellhousings

I do not know a definitive answer and so I, like you, will wait for
someone more knowledgeable to weigh in.  However,  manual and PG use
different front supports, so any difference in the depth of the
bellhousing would be accommodated by the different supports.

--Bob

On 6/21/2018 9:59 AM, Charles Sadek via VirtualVairs wrote:
> Are the PG bell housings and the manual bellhousing the same depth 
> (between
> block and differential)? I believe they are. If there were differences,
> there would be installation issues at front trans cross member.
>
> Thanks
>
> Chuck S
>
>

_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are 
the property
of the writer, please attribute properly. For help, 
mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, 
http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
_______________________________________________