<VV> One Low-Beam Out... Sometimes

[Seth Emerson]

Mike - Probably a dead low-beam filament in that right side bulb. The low beam bulbs have two filaments, one comes on with the low beam feed (or doesn't in this case), when you switch to high beams, the low-beam filament is disconnected and the high-beam filament fed the voltage. New low beam bulb should do it! -Seth


-----Original Message-----
From: Michael Mauro via VirtualVairs <virtualvairs at corvair.org>
To: virtualvairs <virtualvairs at corvair.org>
Sent: Fri, Apr 3, 2020 10:08 am
Subject: <VV> One Low-Beam Out... Sometimes


Re: my 67 coupe... with low-beams selected, right-side low-beam is out; when I press the floor switch for high-beam, all four beams illuminate. Question... do I need to replace the right-side low beam; or, is there a wiring issue? (Of course, if the fix is a new bulb, I'll replace both to insure the same amount of illumination). Please advise. Thinks! 
Mike Mauro 
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
 _______________________________________________