<VV> FC West coast mirror top bolts needed
Charles Sadek
Chsadek at comcast.net
Fri Jun 19 16:12:42 EDT 2020
Thanks Bob.
From: Robert Marlow, Vairtec Corporation [mailto:vairtec at optimum.net]
Sent: Friday, June 19, 2020 4:07 PM
To: Charles Sadek
Subject: Re: <VV> FC West coast mirror top bolts needed
I've been down this road with my '64 Greenbrier; I made my own by cutting down (actually, grinding down) hardware store bolts.
--Bob
On 6/19/2020 3:58 PM, Charles Sadek via VirtualVairs wrote:
Hi Folks,
I am rebuilding my FC west coast mirrors. The mirror is held thru a bracket
with two bolts on top and two brackets on the bottom below the vent window.
The top two small bolts on each side go from the inside of the vertical top
of the front door into a bracket attached to the outside with two thin
partial hex-head ¼-20, ¼”-3/8” inch long machine screws. The heads look
like a very thin hex with most of three sides removed to make a flat edge
which goes against the inside horizontal portion of the top of the door to
keep from turning. The bolt goes thru the door, thru a bracket and is
secured with an acorn nut. Anyone have a source? I need four.
If not, I will make my own.
Thanks,
Chuck Sadek
--
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
-------------- next part --------------
A non-text attachment was scrubbed...
Name: image001.jpg
Type: image/jpeg
Size: 18700 bytes
Desc: not available
URL: <http://www.vv.corvair.org/pipermail/virtualvairs/attachments/20200619/9889baa7/attachment.jpg>
More information about the VirtualVairs
mailing list