<VV> PCV for FC 164 cu in

[William Hubbell]

Looks nice, but how do you now remove the cross pipe if you need to?

Bill

On May 5, 2020, at 6:30 PM, N2VZD TIM via VirtualVairs <virtualvairs at corvair.org> wrote:

I have made a mod to my air cleaners using  very rusty cleaned up parts . I figured it was a good use. I cut a late PCV pipe off and fed it to the cross pipe thru a 1/2 inch hole cut with a chassis punch. I also opened up the air intake after removing the baffle. As it was the air intake was half the size in the center. It now gives the same size hole as the intake port on the filter cup.This leaves the center baffle alone. There are pictures for a while on my website for ham radio at    www.qsl.net/n2vzd      Just had some time to tinker with my own motor for a change..looks clean and simple , seems to work good.  Staying put in my shop for now lots of sadness all around here.Regards, Tim Colson C N Y C C



_______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
_______________________________________________