<VV> Clutch question

[GW]

Believe there is a difference in the pivot ball / stud for the throw out bearing clutch arm. 

Between early and late design.

Thanks,

Greg

> On Jul 15, 2025, at 11:54 AM, Steve Gangi via VirtualVairs <virtualvairs at corvair.org> wrote:
> 
> I've installed a 63 engine in a 64 convert. using the 63 flywheel, pressure plate and throw out bearing and a new clutch cable. I'm having trouble adjusting the clutch cable where it feels good. Car is still up on jackstands and haven't run the motor yet. Did I miss something? (while its still up in the air)
> Steve GangiNew Haven, CT
> 
> 
> Sent from the all new AOL app for Android
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
> Archives: http://www.vv.corvair.org/archive.htm
> _______________________________________________