<VV> Clutch question

[ohareck at aol.com]

I agree. I had the same problem with a rampside. Couldn’t adjust the clutch until I changed that part. Charlie 


Sent from the all new AOL app for iOS


On Tuesday, July 15, 2025, 2:03 PM, GW via VirtualVairs <virtualvairs at corvair.org> wrote:

Believe there is a difference in the pivot ball / stud for the throw out bearing clutch arm. 

Between early and late design.

Thanks,

Greg

> On Jul 15, 2025, at 11:54 AM, Steve Gangi via VirtualVairs <virtualvairs at corvair.org> wrote:
> 
> I've installed a 63 engine in a 64 convert. using the 63 flywheel, pressure plate and throw out bearing and a new clutch cable. I'm having trouble adjusting the clutch cable where it feels good. Car is still up on jackstands and haven't run the motor yet. Did I miss something? (while its still up in the air)
> Steve GangiNew Haven, CT
> 
> 
> Sent from the all new AOL app for Android
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
> Archives: http://www.vv.corvair.org/archive.htm
> _______________________________________________

 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
Archives: http://www.vv.corvair.org/archive.htm
 _______________________________________________