<VV> 66 Coupe Roof Rail Weatherstrip

gerg gergwerks at comcast.net
Tue Jul 9 16:00:31 EDT 2013

I just put them in on my '67 and they fit fine. My passenger side seals fine, but the vent window frame on my driver's side needs a small adjustment forward as it is not lined up correctly (the top). It touches nicely from the door top and pulls away slightly about 1/2 - 3/4 of the way up. Just enough to whistle a little at speed. I see what looks like an adjustment screw in the door jamb. 

 The seals fit great though IMO. I just pushed a tad of slack into the corner as I installed it so it fit tight through the bend. 


Greg Blakeney
(318) 680-9224

On Jul 9, 2013, at 2:13 PM, eamsquared at comcast.net wrote:

> Clark's PN 7914 does not have the molded in miter above the vent window.  What has been the communities experience using Clarks weatherstrip to replicate the miter joint?  Do you cut Clark's molding to fabricate the miter joint or does the weatherstrip fit into the retainer in one piece and still function properly? 
> Erich Meyer 
> Bayshore Corvair 
> _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs 
> _______________________________________________

More information about the VirtualVairs mailing list