<VV> Diff wanted

jvhroberts at aol.com jvhroberts at aol.com
Sat May 31 15:57:22 EDT 2014


 If you don't have the yoke nuts and use early yokes (which you have to do on an early no matter what diff you use), there's no discernable difference in this aspect. 

 

John Roberts
 

 

-----Original Message-----
From: Frank DuVal via VirtualVairs <virtualvairs at corvair.org>
Cc: VirtualVairs <VirtualVairs at corvair.org>
Sent: Sat, May 31, 2014 2:40 pm
Subject: Re: <VV> Diff wanted


That's what I meant. The whole unit including bolted in yokes is the wrong 
dimension. The complete late assembly is too wide. Use the early yokes, etc. The 
cast iron case is the same dimension. 

I used a late in an FC and it put the axles in a bond. I worked on a rampside 
with a whole late assembly, and whoever installed it cut a section out of each 
axle. 

I would like to know what Mark is bolting to the side of a late diff in a 65 
Greenbrier. 

Frank DuVal

On May 31, 2014, at 2:17 PM, jvhroberts at aol.com wrote:

> Negative. They're the same. But, the yokes on the earlies slide, making the 
measurement moot. The side adjusters, etc., are all the same. In fact (but why 
would you want to?) you can use an early diff in a late case and vice versa, as 
long as you put the yoke nuts in for the lates. 
> 
> John Roberts
> 
> 
> -----Original Message-----
> From: Frank DuVal via VirtualVairs <virtualvairs at corvair.org>
> Cc: VirtualVairs <VirtualVairs at corvair.org>
> Sent: Sat, May 31, 2014 1:56 pm
> Subject: Re: <VV> Diff wanted
> 
> Isn't the late model differential wider, yoke to yoke, than the early model?
> 
> You might need to shorten the axle shafts to use it. 
> 
> Frank DuVal
> 
> On May 31, 2014, at 9:43 AM, Mark Corbin via VirtualVairs <virtualvairs at corvair.org> 

> wrote:
> 
> > Wanted: Diff (bare case or complete) for a ‘65 ‘Brier w/automatic. Must be 
the 
> ‘65 car style with the lower control arm attachment bolt pads, not the EM 
style 
> which doesn’t have them.
> > 
> > -Mark Corbin
> > 5474 S.R. 19
> > Galion, Ohio 44833
> > 419-468-4942
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the 

> property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
>  _______________________________________________
 _______________________________________________
This message was sent by the VirtualVairs mailing list, all copyrights are the 
property
of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
This list sponsored by the Corvair Society of America, http://www.corvair.org/
Post messages to: VirtualVairs at corvair.org
Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
 _______________________________________________

 


More information about the VirtualVairs mailing list