<VV> 66 4 speed transmission grinding

james davis jld at wk.net
Thu Dec 1 20:33:15 EST 2016

It is a brass blocker ring than needs replacing.  Syncronizers almost 
never go bad.  Your trans has four blocker rings; one for each gear.  It 
you need to replace one you might as well do all four.  You do need a 
few special tools but it is not hard once you get the transmission on 
the bench.  Clarks carries the parts 
Jim Davis

On 12/1/2016 6:29 PM, Mike Callahan via VirtualVairs wrote:
> Everytime I shift into 4th gear, I get a grinding noise.  I am guessing it
> is a synchronizer.  Any other ideas?  What parts do I need and where can I
> get them?
> Thanks
> Mike Callahan
>  _______________________________________________
> This message was sent by the VirtualVairs mailing list, all copyrights are the property
> of the writer, please attribute properly. For help, mailto:vv-help at corvair.org
> This list sponsored by the Corvair Society of America, http://www.corvair.org/
> Post messages to: VirtualVairs at corvair.org
> Change your options: http://www.vv.corvair.org/mailman/options/virtualvairs
> Archives: http://www.vv.corvair.org/archive.htm
>  _______________________________________________

More information about the VirtualVairs mailing list